Our continuous cutting, as long as the machine is opened, the fabric belt does not stop for one second, the fabric roller and the compaction roller are also non-stop. Because this is the only way to ensure the uniformity of the fabric, it is rarely broken. Most of the dicers currently on the market are taking a few seconds to stop. After each stop, the fabric belt, the fabric roller, the compaction roller, the cutting feed roller, etc. must be restarted, and the time at which several components are restarted cannot be consistent, thus damaging the material waiting for cutting. There are a lot of cracks in the food to be cut, and a lot of damage will be found during the cutting and packaging process. Our company has done a lot of research work to overcome the above problems, such as the synchronization of the fabric roller, compaction roller, cutting feed roller and conveyor belt, install the synchronizer, install several tensioning pulleys on the chain, reduce Gear clearance, using MCU and PLC cooperative control, did not solve the above problems. Finally, it was found that only the cloth roller, the conveying belt, the compaction roller and the like were always moving at a constant speed, and it was not allowed to stop to solve the problem. Therefore, the fabric, compaction, feeding and cutting of the automatic flat cutting machine of Wuhan Xianglaer Company are continuous without stopping, so the cut food has low breakage rate, high efficiency, labor saving and time saving. The food is neat and beautiful, and the tightness is consistent.